EngraverTextT is shown below. The Engraver Text fonts correspond to the standard fonts used for
the text portions of the font: T for Times, H for Helvetica and NCS for New Century Schoolbook.
The following characters are available in EngraverFontSet and EngraverFontExtras only.
These are noteheads with the let ring symbol. By having the let ring symbol directly attached to the notehead, consistency of the symbol placement is achieved. These noteheads can be accessed through the Special Tools tool (change notehead). First enter the notes with any of the Finale note entry methods, then with Special Tools tool change the notehead.
Also included are the two “let ring” symbols for input with the articulation tool.
Set One: Full Size
These noteheads are provided for “trill to” notes when they are to be outside of the staff. First, enter the notes with any of the Finale note entry methods. Then use a combination of tools from the Special Tools tool to edit the note: use the Note Shape tool to change the notehead, use the Stem Length tool to shorten the stem, and use the Note Position tool to move the note to the desired horizontal position.
Set Two: 75% Reduction
These noteheads are already reduced to 75% and can be used as “trill to” notes for use within the staff. Enter with the Articulation tool .
These noteheads allow for a quick and consistent way to input tone-clusters. After inputting notes, use the Special Tools tool to change the noteheads.
Type away! Make whatever dynamic possible. There are two sets of parentheses for use. The and markings need more space than the other symbols, so use the SHIFT+[ and SHIFT+] both before and after any dynamic with an and before any marking with a .
Engraver Font Set
Engraver Font Extras